Pedestals The equipment is mainly used in the manufacture of large diameter, column caps, ball vertical lathe classification, the device is controlled by computer, automatic processing four meters vertical lathe, with a variable frequency speed, easy to operate. 1. This machine is suitable for all sectors of the machining, it can be used for the outer cylinder, round-dimensional surface, end, grooving and cutting of coarse and fine turning. 2, table hydrostatic guideway, radial shaft using high-precision NN30 type (D grade) bearings, slewing precision high load capacity. Vertical machining center lubrication system is simple to say, is to separate feeding of lubricating oil and compressed air are mixed and after the formation of turbulent flow of oil and gas mixture stream supplied to the machining center spindle section or other lubricating parts. Li vehicle under normal operation to must meet the following requirements, the machine can not place the orientation of the supply voltage amplitude fluctuation is not easy too large, the ambient temperature is below 30 degrees Celsius, the relative humidity to less than 80%. Vertical lathe Category | vertical lathe to find Henderson | vertical lathe provided by the Henderson Mine Machinery Co., Ltd., Zhengzhou. Henderson Zhengzhou Mining Machinery Co., Ltd. (www.zzhjks.com) is Zhengzhou, machining leaders, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. Henderson Mine in Zhengzhou leadership with the staff warmly welcome all inquiries negotiations to create the Zhengzhou Henderson mine better future.